Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
en:preparation:flashtoolinstall [2019/12/04 10:06] kniwwelino |
en:preparation:flashtoolinstall [2019/12/30 09:56] (current) kniwwelino [Installing the Kniwwelino Flashtool] |
||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ===== Installing the Kniwwelino Flashtool ===== | ||
+ | |||
+ | - Download the latest release: | ||
+ | * {{ : | ||
+ | * {{ : | ||
+ | - Unzip it somewhere on your PC. | ||
+ | - Run the file '' | ||
+ | - Plug your Kniwwelino board with an USB cable to your PC | ||
+ | - Make sure the COM port of your Kniwwelino board appears as available port in the dropdown list. | ||
+ | |||
+ | The installation was successful, you can continue with [[en: | ||
+ | |||
+ | |||
+ | ==== If needed: Find the COM port of your Kniwwelino ==== | ||
+ | Do the following steps to find out the COM port of your Kniwwelino: | ||
+ | |||
+ | - Plug your Kniwwelino to your PC. | ||
+ | - Open the device manager (through the control panel or search for it in the Windows search box) | ||
+ | - Check the entry '' | ||
+ | |||
+ | {{ : | ||
+ | |||
+ | ==== If needed: Install the CH340g driver ==== | ||
+ | |||
+ | In case you don't find a new serial device in the Device Manager after plugging a Kniwwelino to your PC. You should install the driver. | ||
+ | |||
+ | Download and unzip the CH340g driver available from [[https:// | ||
+ | |||
+ | Depending on your account rights you maybe have to start '' | ||
+ | |||
+ | After launching a window like this should open and by pressing the install button the driver will be installed. | ||
+ | |||
+ | {{ : | ||
+ | |||