Show pageOld revisionsBacklinksBack to top This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong. ====== Adding external Sensors ====== External sensors can be connected to the Kniwwelino through the pins available on the outer area. Most Sensors need to be connected to the GND and 3.3V pins of the Kniwwelino, as well as one or more of the outer pins on the lower outer side of the Kniwwelino. Please see the specific sensor section for more details. You can read the sensor data and use it in your application with the specific block, listed in ''Sensors'': ===== Supported Sensors ===== ==== HC SR04P ==== * ** Available Values:** * Distance in cm [0-400] * **Used Library:** Library 1.0.0 https://github.com/Martinsos/arduino-lib-hc-sr04 * **Connection Pins:** * Sensor **Vcc**: 3.3v * Sensor **Trig**: D0 * Sensor **Echo**: D5 * Sensor **Gnd**: GND ==== DS18B20 ==== Temperature sensor from Maxim Integrated Products [[https://datasheets.maximintegrated.com/en/ds/DS18B20.pdf|datasheet]] * ** Available Values:** * Temperatur in Celsius [-55-125] * **Used Libraries:** * OneWire 2.3.4 https://github.com/PaulStoffregen/OneWire * DS18B20 0.1.0 https://github.com/RobTillaart/Arduino/tree/master/libraries/DS18B20 * **Connection Pins:** * Sensor **Vcc**: 3.3v * Sensor **Signal**: D5, D6 or D7 * Sensor **Gnd**: GND * Sensor Signal to Vcc: 4.7kOhm resistor en/extensions/extothersensor.txt Last modified: 2019/04/10 13:30by kniwwelino Log In