en:preparation:flashtoolreset

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision		 Previous revision
en:preparation:flashtoolreset [2019/12/30 09:59] – kniwwelinoen:preparation:flashtoolreset [2019/12/30 10:19] (current) – kniwwelino
Line 1: Line 1:
 +===== Resetting a Kniwwelino board using the Kniwwelino Flashtool =====
  
 +For the following procedure you need a PC or Mac with the Kniwwelino Flashtool installed. For more information on how to install the Kniwwelino Flashtool see [[en:preparation:flashtoolinstall|]].
 +
 +1. Open the Flashtool. The following window will show.
 +
 +{{:en:preparation:flashtool_01.jpg?300|}}
 +
 +\\
 +2. Select the COM port where you Kniwwelino is connected to (number might differ)
 +
 +{{:en:preparation:flashtool_02.jpg?300|}}
 +
 +\\
 +
 +3. Click on “Reset to factory defaults”
 +
 +{{:en:preparation:flashtool_08.jpg?300|}}
 +
 +\\
 +The message “Writing Firmware” will appear. After about 30 seconds, the Kniwwelino will reboot and a demo programm will run.