For the following procedure you need a PC or Mac with the Kniwwelino Flashtool installed. For more information on how to install the Kniwwelino Flashtool see Installing the Kniwwelino Flashtool.

1. Open the Flashtool. The following window will show.

2. Select the COM port where you Kniwwelino is connected to (number might differ)

3. Click on “Reset to factory defaults”

The message “Writing Firmware” will appear. After about 30 seconds, the Kniwwelino will reboot and a demo programm will run.

  • en/preparation/flashtoolreset.txt
  • Last modified: 2019/12/30 10:19
  • by kniwwelino